1-28 (No.RA053<Rev.001>)
3.2.7 Removing the TX-RX unit from the chassis
(1) Remove the following parts in numerical order.
<1>PACKING ASSY <2>VOL/SEL FPC <3>PTT FPC
<4> nine screws
Note:
The FPC is locked with an actuator.
Raise the actuator straight upward, then make sure
the actuator is perpendicular to the insulator.
3.2.8 Removing the TOP packing
(1) Pull the TOP packing to the left to remove the packing that
is fit into the left groove of the chassis. <1>
(2) Pull the TOP packing to the right to remove the packing that
is fit into the right groove of the chassis. <2>
(3) Pull the TOP packing to the center to remove the packing
that is fit into the center groove of the chassis. <3>
(4) Remove the TOP packing. <4>
Note:
Remove the packing slowly, as the packing of the
selector part might be overset when the TOP packing
is removed.
If the packing is turned over, return it to the original
position using a soft tipped item (e.g., your finger).
<4>
<4>
<4>
<4>
<4>
<4>
<4>
<4>
<4>
<1>
PACKING ASSY
<3>PTT FPC
<2>
VOL/SEL FPC
perpendicular
straight upward
Actuator
Insulator
Front contact
<4>
<1>
<2>
<3>
TOP packing
