Recording on MD
34
Preparation section
Basic section
Apprication section
Knowledge section
Press during recording.
Blinks
Turning the monitor mode ON (External digital component) (MONITOR)
1
Press the menu/demo key.
2
Rotate the volume/multi-control knob to select
“MONITOR ?”, then press the set key.
3
Select “ON” by rotating the multi-control knob,
then press the set key.
M
ONITOR
?
M
ONITOR
ON
‰
R
EC
I
NPUT
?
R
EC
T
NO
M
ARK
?
R
EC
T
NO
M
ARK
AUTO
‰
Blinks
Select the recording input signal as required.
Selecting the recording input signal (REC INPUT)
1
Press the menu/demo key.
2
Rotate the volume/multi-control knob to select
“REC INPUT ?”, then press the set key.
3
Select the desired recording input signal by rotat-
ing the volume/multi-control knob and press the
set key.
÷
When recording from a CD or MD, digital recording of certain
discs may be inhibited by the SCMS*. With such a disc,
record the
ANALOG
input signal. (*SCMS
fl
)
Blinks
Track number marking in MD recording (REC TNO MARK)
1
Press the menu/demo key.
2
Rotate the volume/multi-control knob to select “REC
TNO MARK ?”, then press the set key.
3
Select “AUTO” or “MANUAL” by rotating the vol-
ume/multi-control knob, then press the set key.
Blinks
Blinks
AUTO
Usually, use this position for recording. When CD playback is recorded, the MD track number increments as the CD track
changes. When an external input is recorded, the MD track also increments by
“1”
at the moment the input signal which has
been below a certain level for more than 2 seconds increases above the level. (When tuner reception is recorded, the track
number may sometimes fail to increment due to signal noise, etc.). When recording music containing a continuous section with
a very low level, for example when recording classic music, the track number may be incremented by
“1”
after such a section.
In this case, cancel the track number later. It is recommended to use the
MANUAL
mode when recording such a kind of music.
During digital recording of CD, the track number is incremented automatically by
“1”
according to the data contained in the
digital information. The no-sound blank is not detected.
When the CD track number is increased during manual search of a CD, the track number recorded on the MD may sometimes
fail to be incremented.
A no sound track may sometimes created at the moment the played CD stops.
The audio being recorded from an external source component
can be listened to (monitored) through this audio system.
When you press the set key while “REC TNO MARK” is displayed, a menu for selecting whether the track
numbers are to be marked automatically during recording (AUTO) or marked manually by yourself during or
after recording (MANUAL). Select either option with the volume/multi-control knob and press the set key.
The initial setting is “AUTO”. The track numbers are used when playing back the recording, searching for a
track or programming tracks.
÷
The audio cannot be monitored while “
READING
” or “
WRITING
” of MD is displayed.
Recorded source
Recording input signal
TUNER
MONO/ANALOG
CD
ANALOG/DIGITAL/MONO
AUX
MONO/ANALOG
AUX(MD)
Digital only
TRACK EDIT
MANUAL
With this setting, the MD track number is not incremented automatically during recording. Track
numbers can be marked either during editing (by pressing the
TRACK EDIT
key) or after recording
(by executing the DIVIDE operation
W
).
This setting is convenient when recording a CD which has been recorded in live or which contains
very low-level sound such as a classical music CD.
