23
Basic section
TAPE EQ.
TAPE EQ.
STOP
7
T
0000
APE
S
TOP
R W
E
T
0152
APE PLAY
R W
E
menu
down
volume/
multi control
up
down
volume/
multi control
up
set/demo
set/demo
Playback of tape
To wind tape at high speed
÷
Press the
7
STOP
key to stop fast winding.
To fast wind in
direction
|
To fast wind in
direction
\
Selection of TAPE equalizer (TAPE EQ.)
(Remote control unit only)
When playing a tape prerecorded with Noise Reduc-
tion system (such as the DOLBY NR) ON, be sure to
set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1
“TAPE EQ.” ON
TAPE equalizer is used.
2
“TAPE EQ.” OFF
TAPE equalizer is not used.
Lit when “TAPE EQ.” is ON
÷
Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
÷
Normal (TYPE ), high (TYPE ), or metal (TYPE
) tape
selection is set automatically.
÷
Remove tape slack before loading.
To stop playback
Selection of reverse mode
(Main unit only)
Reverse mode indication
Displayed when the deck is loaded with a tape.
1
Select “TAPE RVS. ?”.
2
Select.
3
Set it.
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the
2
tape transport indicator is lit). To set the tape
counter to “0000”, open the cassette holder once. Then
the counter will be reset.
1
“ ” : (REVERSE)
Both sides are played back (recorded), and then the
tape stops.
2
“
”:
(ENDLESS)
Both sides are played back endlessly.
(The tape stops after recording onto both sides.)
3
“ ”: (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
(Press the set/demo key while the “?” mark
is blinking.)
(The initial setting is " " (REVERSE).
4
¢
Tape counter
Do not use a cassette with more than 90-minute re-
cording time, for the tape used with such a cassette
is very thin and tends to cause troubles such as en-
tanglement around the pinch roller or cutting of
tape.
Transport direction indicators
Summary of Contents for HM-382MD
Page 27: ...27 Basic section ...
Page 38: ...38 Application section ...
