Before using this appliance, it must have the castor plates and castors fitted.
ASSEMBLY
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall.
Be careful to prevent damage to the cosmetic finish or your floor surfacing.
2. Screw off the wing nuts from the U-shaped bolt provided, fit the U-shaped bolt over the connector
between first and second fins (near the front cover).
3. Insert the threaded ends of the U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over-tighten, which may cause damage to the heater.
5. Remove the dome nut from the castors, fit castor thread through the castor mounting plate. Replace
dome nut and tighten.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.
Note: the rear castors must be mounted between the end two fins.
IMPORTANT: Please fit the wheel assemblies as per the diagram. Any other position may affect the
stability of the heater.
WARNING: Only operate the heater in normal upright position with wheel assemblies
attached to the bottom, any other position could create a hazardous situation.