![background image](http://html1.mh-extra.com/html/kensington/hb-ntq/hb-ntq_instruction-manual_664077012.webp)
12
0800 422 274
NZ
Selecting the heat setting in AUTO mode
• Press the HEAT button: the top half of the body figure and the heat setting for
that zone will flash.
• Use the [ + ] or [ - ] buttons to set the desired heat level for that zone.
• Press the HEAT button again: the bottom half of the body figure and the heat
setting for that zone will flash.
• Use the [ + ] or [ - ] buttons to set the desired heat level for that zone.
Instructions (Cont.)
• Press the HEAT button and both settings will be
confirmed, the heat button will illuminate and
heating will start.
• Once the AUTO start time is reached, heating
will begin and the HEAT button will be
illuminated.
• For the first 20 minutes in AUTO mode, the
electric blanket will operate in BOOST mode
at the highest heat settings. At the same time,
the CLOCK image will disappear from the LCD
display and the full body figure and the [ H ] in
both heat zones will be illuminated.
• After the first 20 minutes, the LCD display will
show the programmed heat zone settings.
• Once the AUTO Finish time is reached, heating
will stop and the HEAT button will no longer
be illuminated. At the same time, the CLOCK
image will reappear and the full body figure will
disappear from the LCD display, indicating that
the zone is no longer heating.
NOTE: The last programmed AUTO Start and
AUTO Finish times will remain programmed in the
AUTO mode settings unless manually changed, or
until power is disconnected at the power outlet.
HINT: To clear previous settings completely, the
electric blanket must be disconnected and then
reconnected to the power outlet. This will, however,
remove the clock setting. Always remember to
reset the clock setting before using AUTO mode.
Summary of Contents for HB-NTQ
Page 1: ...MODEL NUMBER HB NTQ N13275...