10
INSTALLATION INSTRUCTIONS
CONNECTING THE DRAIN HOSE
CONNECT TO THE POWER SUPPLY
• The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
fl
ooding and property damage.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
Option 1: Standpipe
Option 2: Laundry Tub
Bend the end of the drain hose to the desired shape
and support it on the edge of the laundry tub. Use a tie
strap to secure the drain hose in place.
Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet. Plug in the washer.
Drain Hose
Tie Strap
Laundry Tub
Improper connection of the equipment-grounding
conductor can result in risk of electric shock. Check
with a quali
fi
ed electrician or service technician
if you are in doubt as to whether the appliance
is properly grounded. Do not modify the plug
provided with the appliance. If it does not
fi
t the
outlet, have a proper outlet installed by a quali
fi
ed
electrician. Failure to follow these warnings can
cause serious injury,
fi
re, electrical shock, or death.
WARNING
If your drain is a standpipe, fasten the drain hose to the
standpipe with the cable tie provided.
NOTE:
• Normal height of the end of the hose should be approximately
35”~47” (0.9~1.2 m) from the
fl
oor.
• Do not install the end of the drain hose higher than 96 in.
(243.8 cm) above the bottom of the washer or more than 60
in. (152.4 cm) away from the washer.
• Never seal the drain hose to the drain. If no air gap is
present, water can be siphoned out of the tub resulting in
poor wash/rinse performance or clothing damage.
Bend the outlet end of the drain hose to form a U shape. Insert
the end of the drain hose into the drain. If the drain is large
enough for the
fl
ange on the hose to
fi
t inside, then do not insert
the
fl
ange more than 1-2 inches into the drain. Use the tie strap
included with the installation materials in the foam block in the
tub to secure the drain hose to the drain.
Cable Tie
35"~47"
(0.9~1.2 m)
Cable Tie
35"~47"
(0.9~1.2 m)
If the water valves and drain are built into the wall,
fasten the drain hose to one of the water hoses with the
cable tie (ribbed side on inside).
Drain Line
Standpipe
35"~47"
(0.9~1.2 m)
Summary of Contents for 796.3141#31#
Page 66: ...66 NOTA ...
Page 67: ...67 NOTA ...
