Burner and Firebox and Control Knobs
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24x1/2’’
machine screws
.
Inside firebox, insert heat diffuser supports with 5x15 fiber washers to firebox through sides of firebox, then secure with
on outside of firebox (A).
Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,
adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor ( B ).
Attach firebox with #10-24x1/2’’ machine screws, 5x15 fiber washers and #10-24 flange nuts ( C )
Push control knobs onto valve stems ( C ).
(A)
#10-24 flange nuts
.
11
Burner assembly
Firebox
Heat shield
for Tank
Valve
Burner tube
Make sure the burner tubes are located
underneath Heat Shield
B
5x15
Fiber Washer
Qty.10
#10-24
Flange Nut
Qty. 8
#10-24X1/2”
Machine Screw
Qty.6
Heat diffuser Support
Qty.4
Heat diffuser
support
Control Knob
A
C
18 • 464722309 • 464722509
Valve
Burner Tube
Correct burner-to-valve engagement
