Attaching to a CLAAS Forage Harvester
KM00321,00009B6 -19-14NOV19-1/4
Continued on next page
KM00321,00009B6 -19-14NOV19-2/4
Attaching to a type 498 forage harvester with
variable header drive
Rotary harvesting units for the Claas type 498 forage
harvesters are technically partially prepared for the
variable header drive.
In addition, programming steps are required in the
forage harvester software, which must be matched
with Claas. To do this, contact your Claas dealer.
IMPORTANT: In order to use the variable header drive,
the A130FAM module must be programmed
for it. Otherwise, the rotary harvesting unit
can only be used with constant speed and the
adjustment of the header speed is carried out
via the Kemper multi-speed gearbox.
NOTE: For rotary harvesting units that are equipped
for mounting a support wheel, first it is necessary
to delete the existing software on the rotary
harvesting unit module. Then the module
name A130FAM is visible.
Programming of the A130FAM module takes place via the
forage Harvester. To do so, proceed as follows:
1. Attach the rotary harvesting unit to the forage
harvester.
2. Connect the forage harvester to a computer and start
the Claas Diagnostics System (CDS).
3. Select the A130FAM module for programming the
rotary harvesting unit.
KM359969
—UN—22FEB19
4. When entering a serial number, enter
released by
Claas.
IMPORTANT: Enter a serial number of a rotary
harvesting unit that corresponds to the working
width of the Kemper rotary harvesting unit.
KM359968
—UN—22FEB19
25-2
120519
PN=33
