17
. Install transport control assembly. The transport control assembly consists of one threaded
eyebolt on which two nuts are already installed and a length of square tube into which the
eyebolt slides. The eyebolt is attached to the bottom set of holes in the mast head. The tube is
then slid over the eyebolt and attached to the clevis on the underside of the transport. Once
installed, tighten the nuts against the tube.
18
. Install the levelling assembly between the mast and the frame. There should be no pressure
against the spring.
19
. It is now possible to lift the hitch of the disc and remove the support from under the frame.
Leave the tire chocks in place. At this point the hydraulic hoses can be connected to the cylinder
but do not charge the system.
28
