Assemble the Disk
□ The disc is normally shipped with the bridle and transport assemblies attached to the frame. The
gang assembles are bolted to the gang bars and the scrapers are bolted to the scraper bars. The
hitch, side arm, levelling control assemblies, transports control assemblies, jack and hose holder
are bundled together. Tires are shipped loose and the remaining components (hydraulics,
lighting, hubs, etc) are crated.
□ The parts diagrams in this manual may facilitate assembly of the disc.
□ These instructions require a forklift, boomlift or similar type of equipment which is capable of lifting
the disc weldments. A minimum 8000 lb outdoor application forklift with fork extensions is a good
choice. A tractor to move the disc and charge and operate the hydraulic cylinder will also be
required.
□ The following tools will also be required:
1. A selection of chains and straps.
2. Box end wrench set to 1-1/4” plus 1-5/16” and 1-1/2”.
3. Socket and rachet sets to 1-1/4” plus 1-5/16” and 1-1/2”.
4. Hammers and sledge hammer.
5. Pinch bar.
6. 12” adjustable wrench.
7. Pliers and vise grips.
8. ½” and ¾” drive air wrench and sockets.
1
. Stand the hubs on end (remove from transport assembly if installed for shipment) and place
wheels on top and install and tighten wheel bolts.
24
