Kellfri 35-FDM240, Manual

Page: 24 / 48

24 Table of Contents
CONNECTING THE EQUIPMENT
• Place the equipment on a hard, level surface. (Do not allow the equipment to overturn.)
• Lower the tractor's 3-point linkage to the same height as the machine's 3-point linkage.
• Connect the machine to the tractor's rear 3-point linkage.
• Connect the PTO shaft. Secure the chain properly. Make sure the chain does not hang down
or otherwise become trapped in the machine during operation.
• NOTE
Check that the transport locking device has been removed before starting work.
• Connect hydraulic hoses. Raise the equipment and check its functioning.
• Ready for use.
0-13 cm
Distance of installation between
rotary disc mower and tractor.
See red arrows below.
Transport locking device must be fitted
during transportation - see illustration.
Horizontal position
The rotor cutterbar can be angled to +90° and -30°
Remove the transport locking device
and adjust the angle of the cutterbar.
Make sure you do not hit any obstacles.
Important! Always check the surroundings
before making the adjustment.