- 16-
3.2
Installation of Light Curtain
3.2.1
Common front mounting (PZ)
It refers to the installation mode that the emitter and receiver are directly installed on the machine
body with common mounting bracket. It is generally applicable to the closed pressure machine with
framed structure. Installing form as shown in Fig.3.2.1. The installation steps are as follows:
1
M4×8 cross recessed screw,
Φ
4 elastic/plain washer
②
M5×16 inner hexagon screw,
Φ
5 elastic/plain washer
③
LCS vibration-mounting bracket
④
LCS vibration-reducer
⑤
Emitter/ Receiver
Fig.3.2.1
Common front mounting (PZ)
A. The installation position of emitter and receiver should be determined according to the
calculated safety distance and height. Care should be taken to ensure that the emitter can be
installed parallel to the receiver.
B. Connector plug-in of sensor should be penetrated the middle hole of LCS vibration-mounting
bracket. Pay attention to the bracket installation hole down when entering.
C. As shown in the graphical direction, connect LCS vibration-mounting bracket and LCS
vibration-reducer with M4x8 cross recessed screws.
D. Fasten LCS vibration-mounting bracket on the bed piece with M5x16 inner hexagon screws.
