Preparing and Installing Your Board
3-9
2. Carefully unwrap your board from its anti-static wrapping material.
(You can store the wrapping material for future use.)
3. Inspect the board for signs of damage. If damage is apparent, arrange
to return the board to the factory (see “Technical Support”).
4. Check the remaining contents of your package against the packing
list, and immediately report any missing items.
5. When you are satisfied with the inspection, continue with the next
procedure, “Setting the Base Address.”
Note:
Your DAS-TC/B is factory calibrated and requires no further
adjustment prior to installation. If at a later time you decide to recalibrate
the board, refer to Section 6 for instructions.
Setting the Base Address
Note:
Before setting the base address switch, check the different
requirements for Windows 95/98 and Windows NT. Refer to “Configuring
the DAS-TC/B” in
Using DriverLINX with Your Hardware—Keithley PIO
Series
manual. (You printed this information in step 10 of “Installing
DriverLINX Software Components and Documentation.”)
The only manually configurable component on the DAS-TC/B is the DIP
switch for setting the board’s base address. Figure 3-1 shows the
7-position DIP switch with factory settings. (Note that the switches set the
values shown only when in the off positions).
