Series 3700 System Switch/Multimeter Reference Manual
Section 3
:
Using the Front Panel
Document Number: 3700S-901-01 Rev. A / August 2007
3-13
MATH
Selecting the MATH menu item opens the MATH MENU. Items contained in this menu are as
follows:
ENABLE:
Enable or disable math operation on measurements. Related ICL command:
dmm.math.enable
(on page 9-99)
FORMAT:
Specifies the math operation to perform on measurements. Related ICL
command:
dmm.math.format
(on page 9-100)
BFACTOR:
Specifies the offset for the y = mx + b operation. Related ICL command:
dmm.math.mxb.bfactor
(on page 9-101)
MFACTOR:
Specifies the scale factor for the y = mx + b operation. Related ICL
command:
dmm.math.mxb.mfactor
(on page 9-101)
MXBUNITS:
Specifies the unit character for the y = mx + b operation. Related ICL
command:
dmm.math.mxb.units
(on page 9-102)
PERCENT:
Specifies the constant to use for the percent operation. Related ICL
command:
dmm.math.percent
(on page 9-102)
NPLC
Configures the integration rate in line cycles for the DMM. Related ICL command:
dmm.nplc
(on
page 9-105)
OFFSETCOMP
Configures the offset compensation setting for the DMM. Related ICL command:
dmm.offsetcompensation
(on page 9-105)
OPENDETECT
Configures the state of the thermocouple or four-wire ohms open detector being used. Related
ICL command:
dmm.opendetector
(on page 9-108)
RANGE
Configures the range of DMM for the selected function. Related ICL command:
dmm.range
(on
page 9-108)
REL
Opens the REL MENU for the selected DMM function. See
REL key configuration
(on page 3-
15).