ASSEMBLING X-BAR COVERS
Step 1:
Obtain the lower cover and screws removed from the previous steps. Set it to the bottom of the
X-Bar carefully (Fig. 29). The clips at the inside bottom of this cover should set over the X-Bar aluminum
casting as shown (Fig. 30). Align and tighten screws with a 2.5mm or 4mm Allen wrench (Fig. 31).
Step 2:
Obtain the front cover and screws removed from the previous steps. While making sure
wire is not in the way (Fig. 32), set it to align with the back cover and tighten screws with a 4mm
Allen wrench (Fig. 33).
26
27
28
29
30
31
32
33
3/4" or
19mm
9
