NOTE:
Use the foam envelope to handle the flywheel during assembly.
Step 3:
Carefully slide the flywheel between the two magnets (Fig 4. & Fig. 5) and onto the hub
at the same time. Make sure that the flywheel is flush against the hub and align the screw holes.
Step 4:
Holding the flywheel in position with one hand, install the hubcap and align the screw
holes. Install the socket head cap screws (M6x1 X 20 SS). Using the 5mm Allen wrench, tighten
the screws in a star pattern until snug (as shown in Fig. 6).
ASSEMBLING PEDAL TO CRANK ARM
Step 1:
Unwrap the pedal set and Loctite 242, obtain the Torque wrench, 15mm crowfoot, 4”
extension, and 15mm open-end wrench.
Step 2:
With a clean cloth, wipe the threaded area of the pedals. Apply Loctite 242 to the pedal
threads. Install the pedals into the crank arms, use the 15mm open-end wrench to tighten. Finish
with the torque wrench, 15mm crowfoot, and 4” extension. Torque pedals to 45 Nm (35 ft-lbs) (Fig. 7).
NOTE:
Left pedal is LH threads and right pedal is RH threads.
!
!
WARNING
: Failing to install the pedals with Loctite 242, or crossing the threads will damage
them, and could result in serious injury to the user.
!
7
5
6
5
