43
Anticipated Inspection
1 Ignition system—obviously continuous ignition abnormality, engine fire or overheating, which requires
inspection and maintenance.
2 Carbon fouling elimination—obviously insufficient horsepower, which requires carbon fouling removal
from cylinder head, piston head and exhaust system.
3 Piston & cylinder—excessive abrasion; replace cylinder if it is blocked.
Please have your motorcycle inspected and adjusted periodically at Qianjiang distributors for being in best
condition.
The above table is established under the presupposition of 1000 km/month.
I—Inspection A—Adjustment R—Replacement C—Cleaning L—Lubrication
Note:
1. “*” Regulations on exhaust emission made by the State Environmental Protection Agency shall be
complied with. Maintenance must be carried out in accordance with the instruction manual supplied by the
company. We are not responsible for any loss rising from private adjustment or maintenance.
2. Increase frequency of washing air filter if your motorcycle runs on the sandy/gravel road or under heavily
polluted environment so as to extend its service life.
3. Motorcycles which often run at high speed or with high mileage shall be maintained frequently.
Engine oil/filter
Oil level
* Note
•
The motorcycle should be parked on a flat ground when
checking its oil level.
• After the engine runs for 2-3 minutes or stops running for
about 2-3 minutes, check the oil level.
Check the oil level.
Add oil to the upper limit when there is an alarm from the oil level sensor.
Oil replacement
* Note
It will be easier to change oil when the engine is warming up.
Turn off the engine.
Remove the drain bolt at the bottom of the crankcase and
discharge oil.
When oil is discharged completely, you can install the drain
bolt and packing washer after they are cleaned.
Add oil to the required level.
