Excalibur 3S installation manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 29 of 35
Use a 17mm spanner to slacken the left hand nut (A) joining the
squaring arm to the main body, make sure the right hand nut (B)
is tight
Release the clamp and position the board such that the blade is
held in the cut on the bottom edge of the board. Press down on
the board to make sure it is in good contact with the squaring
arm.
Turn the squaring adjustment knob (4) on the right hand leg in the
direction described next dependent upon the position of the top
two cuts. If the second cut is to the right of the first cut turn the
adjustment screw clockwise when viewed from underneath. If
the second cut is to the left of the first cut turn the adjustment
screw counter-clockwise when viewed from underneath. The
adjustment screw should be moved so that when the blade is
moved to the top of the board it cuts between two existing cuts,
the plastic sightline fixed to the edge of the clamp gives an
indication where the machine is going to cut.
