Keebox IPC1000WI, Quick Installation Manual

Page: 19 / 27

7. After I successfully configured the IPC1000WI to match my wireless network settings, I
cannot connect to the camera.
1. Verify that the wireless settings match your wireless network settings.
2. Make sure to disconnect the Ethernet cable from the camera and verify that the LINK LED is
blinking red.
8. I forgot my password. What should I do?
Take a pin or paperclip and press the reset button on the back of the unit for 15 seconds. This will
return settings back to factory defaults. Go through the Hardware Installation and Configuration or
Wi-Fi Protected Setup (WPS) Push Button Setup section to reinstall the IP Camera. The default
administrator ID and password is admin.
If you still encounter problems or have any questions regarding the IPC1000WI , please contact
KEEBOX's Technical Support Department.
17