High Speed Dome Camera
User Manual
29
4.3.6
Object Left
Enable this function in the interface to detect specific area at real time. When any object is left in the area,
an alarm will be triggered.
Go to
Settings > Event > Intelligent Function > Object Left
and configure. Setting steps can be
referred to in
Enter Guard Area.
4.3.7
Object Removal
Enable this function in the interface to detect specific area at real time. When any object is taken from the
area, an alarm will be triggered.
Go to
Settings > Event > Intelligent Function > Object Removal
and configure. Setting steps can be
referred to in
Enter Guard Area.
4.3.8
Gathering
Enable this function in the interface to detect specific area at real time. When moving objects exceed the
sensitivity, an alarm will be triggered. After setting the area and the sensitivity is set 50%, when 50% or
more of the area is covered by moving objects, an alarm will be triggered.
Go to
Settings > Event > Intelligent Function > Gathering
and configure. Setting steps can be referred
to in
Enter Guard Area.
4.3.9
Audio Surge
After enabling this function, when there is audio surge, an alarm is triggered. The higher the Voice
Intensity Threshold is, the more sensitive it is to voice mutation.
Go to
Settings > Event > Intelligent Function > Audio Surge
.
Setting steps:
1) Check
“
Enable
”;
2) Drag the slide bar of
Voice Intensity Threshold
to adjust the detection sensitivity to voice mutation.
The higher the Voice Intensity Threshold is, the more sensitive it is to Voice Mutation;
3)
Duration
: Click the white bar behind each weekday and drag mouse to make a blue bar as the task
duration for that day. Select the blue bar and adjust or delete duration by mouse. Check several
weekdays or
“
Select All
” and click “
Copy
” to copy the defined motion detection durations to the days;
4) Check
Linkage Type
and click
“
Save
”.
4.3.10
Alarm Input
Camera supports connecting with on-off alarm devices. If the alarm input device is always disabled, when
it alarms, the circuit will become a loop and the camera will trigger alarm output by the set alarm linkage
type. If the alarm input device is always enabled, when it alarms, the circuit will become open and the
camera will trigger alarm output by the set alarm linkage type.
Setting steps:
1) Confirm that the alarm input device is always enabled or always disabled and has been rightly
connected with the alarm input port of camera.
2) Go to
Settings > Event > Alarm Input
, and select a number from the dropdown list of Alarm Input ID
(corresponding to the connected input ID).
