Keba KeContact P30 x series, Configuration Manual

Page: 62 / 68

Final tasks
62/68
8 Final tasks
8.1 Commissioning the SLAVE charging stations
If needed, make note of the serial numbers of the charging stations be-
fore you close the device covers. The serial numbers are located at the
bottom right of the type place on the charging station.
Put all SLAVE charging stations into operation (see installation manual ).
After commissioning, set the DIP switch DSW2.5 to ON .
This setting allows the charging station to communicate with a higher-ranking system (=MASTER charg-
ing station).
Press the service button and hold it pressed for approx. 1 second until you hear a signal tone.
Then let go of the button again.
The charging station restarts and adopts the DIP switch settings.
8.2 Troubleshooting
For more information and support, please refer to continuously updated FAQ list at www.kecon-
tact.com.