KEB COMBINORM B, Instructions For Use Manual, Page: 32 / 50

32
MOUNTING
4.2.5 Example 4: Brake with armature element - hub neck inside (e.g. 06…10-02-320-xxxx)
4 5
1.2
2.1
8
3
6.4
X
Figure 15: Example 4: Brake with armature element - hub neck inside (e.g. 06…10-02-320-xxxx)
► The shaft mounted brake is pre-assembled. Adjustment of the air gap X is not required.
► Mount the feather key (4) into the shaft (5).
► Push the complete brake (1.2, 6.4, 8) onto the shaft (5) with mounted feather key (4).
► Mount the magnet (1.2) with the socket head screws (2.1) to the mounting surface (3).
► If the magnet flange shall be used as torque arm, the hub is pushed onto the motor shaft (5) with mount -
ed feather key (4) and secured axially on the shaft (5) with the mounted threaded pins (8). The mounting
holes are used to secure the flange to the torque arm.
4.2.5.1 Check air gap X.
Further information on the air gap which becomes larger as a result of wear => „9.2.2
Check air gap“ .
4.3 Tightening torque of the threaded pins
Tightening torques of the threaded pins according to ISO 4026 (DIN 913) .
Threaded pin Tightening torque in Nm
M6 6.3
M8 15
M10 30
Table 5: Tightening torques of the threaded pins