28592_EDEK
ZA0044-0224-1_EN
22
4.
Operation of the multimess F144-PQ
4.1
Getting started
When the power analyser multimess F144-PQ is put into operation for the first time, the
instrument will appear in a guided “Wizard“ mode. The operator is automatically guided
through the initial commissioning of the instrument. This Wizard must be performed
once after the PQ meter has been fully connected.
It is recommended to perform the wizard only after all wiring
has been completed so that no incorrect measurement data is
recorded due to the absence of measurement voltage, currents
or parameters that have not been entered.
Since firmware version 2.0 the recording of the measurement
data is only started after the complete completion of the wizard!
4.2
Initial Setup - Operation of the Assistant
The following actions can be performed using the navigation cross on the
multimess F144-PQ:
Arrow key right / down:
Continue in wizard
Arrow key left / up:
Back in wizard
Enter key
:
Changing parameters
Parameterization
