O p e r a t i n g I n s t r u c t i o n s
|
megaSun pureEnergy 5.0
42
INFORMATION MESSAGES
No.
Info. message
Description
Remedy
203
Fill level aquaCool canis-
ter low
The content of the aquaCool canister is
suffi cient for another 2.5 hours of op-
eration with a spraying time of 6 sec-
onds each.
Replace the empty aquaCool canister with a full
one. Do not replace aquaCool with any other liq-
uid.
204
Connection aquaCool unit
faulty
Communication between control and
module / display has been interrupted.
Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
205
Connection audio module
faulty
206
Connection inside display
faulty
207
aquaCool canister empty
aquaCool canister empty.
Replace the aquaCool canister with a full one.
See chapter: Refi lling Aroma and aquacool.
208
Aroma supply low, please
renew
System has run out of scent.
Replace the Aroma tin.
See chapter: Refi lling Aroma and aquacool.
210
Low battery charge, please
renew
Button cell (CR-2032) of the control
board discharged.
Replace the button cell (CR-2032).
212
Connection RGB module
faulty
Communication between control and
bus module has been interrupted.
Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
213
SD card missing
No SD card in the audio module.
Insert an original SD card.
See chapter: Recording to an SD card/Removing
the SD card.
214
SD card unreadable
SD card defective, incompatible con-
tent.
Insert a new original SD card. Acknowledge the
message by pressing START. See chapter: Re-
cording to an SD card/Removing the SD card. If
the fault persists, contact your Customer Service.
216
Error
voltage
supply,
please check
Power supply to the mainboard varies
Check power supply to the mainboard.
217
No voice fi les on the SD
card, pleas check.
No voice fi les on the SD card found.
Rebuild voice folder on the SD card. If necessary
replace original SD card.
220
OW to many sensors
General OneWire sensor error.
Contact your Customer Service.
221
OW sensor Typ B missing
222
OW sensor Typ S missing
223
OW sensor read error
224
Check tubes and tempera-
ture sensor in the door
Temperature difference to high - be-
tween the one wire sensors.
Check tubes and thermal sensors in the door.
Contact your Customer Service.
228
Check tubes and tempera-
ture sensor in the door
Minimum temperature is not reached or
is fallen below in operation mode.
Check tubes and thermal sensors in the door.
Contact your Customer Service.
229
Pleas close the door, check
exhaust air
Temperature rise of 1,5 degrees in 18
seconds.
Close door. Check exhaust air.
