8
Operation and Service megaSun 7900
A function is switched on by pressing the plus sensor, which is
also used to increase the output stepwise. To set the maximum
value (e.g. fan speed) the sensor
fi
eld has to be pressed again
and again until the maximum value has been reached.
A function is switched off by pressing the minus sensor, which
is also used to decrease the output step by step. To set the
minimum value (e.g. volume) the sensor
fi
eld has to be pressed
again and again until the desired value has been reached.
4.2
Functions
You can use this touch key to switch the apparatus on during the
warm-up time.
If the tanning session has been interrupted by means of the
„Stop“ key, it can be continued after touching the „Start“ key
once again, provided the coin-operated counter has not run
down yet.
The numerical display shows the tanning time.
When the tanning time is over, the running text will appear again
By pressing this touch
fi
eld for at least 2 seconds you can
terminate the tanning session prematurely.
During the tanning program the running time is displayed in this
fi
eld.
When adjusting the volume, the value set between 0 ... 99 % will
be displayed in this
fi
eld for a short time.
When adjusting the fan speed, the value set between 20...99 %
will be displayed in this
fi
eld for a short time
Running time
As soon as the tanning time is over a program to shut down the
sun bed will be started:
• a soft voice reminds you of the end of the tanning session
and says good-bye,
• burners, tubes and the ventilation system will be reduced
step by step,
• the LEDs (in apparatuses with activeColor) will shine in
the colour adjusted for another 20 seconds.
End of the tanning
session