High Speed Camera User Guide
20
The QSFP+ LED’s behavior is described in Table 4:
LED state
Condition
Fast flash red
QSFP+ is unplugged
Solid red
QSFP is not compatible
Slow pulse red
No signal detected on optic fiber
Fast flash green
Link speed is being negotiated
Solid green
Link is active
Table 4 : QSFP+ status LEDs behavior
7.1.2
JetCam Power Connector
The JetCam unit requires 12V power supply for proper function. Please, refer to Electrical
specification section of this document for exact Power Supply requirements.
The positive pin of the power supply connected to the right pin of the connector, shown as “+”,
the negative pin connected to the left pin of the connector, shown as “-“. The power connector is
shown in Figure 7.
- +
Power
Connector
Figure 7 : JetCam camera power connector
NOTE:
Powering up the camera will automatically start SDI transmission for local camera configuration.
Detecting the camera using Vision Point application will turn off the SDI output and the image
will be displayed only via Vision Point application interface. For SDI output, the camera should
be powered cycle.
Hardware Reference
