Assembly instructions Everest
®
engine Base Camp 4140
7 Calibrate the Everest engine Base Camp 4140
|
7.2 Mill the calibration body
▶ Clamp the tools in the double spindle as follows:
- at position T1 = Ti, dia. 1 mm.
- at position T2 = Ti, dia. 3 mm.
▶ Close the safety doors.
▶ Press the Start function key on the control panel.
After approximately 40 minutes, the KaVo Everest engine Base Camp stops.
Exchange tools
The Everest engine Base Camp swings the B axis into the tool exchanging position.
▶ Clamp the tools in the double spindle as follows:
- at position T1 = Ti, dia. 3 mm.
- at position T2 = Ti, dia. 1 mm.
38/51