Assembly instructions Everest
®
engine Base Camp 4140
7 Calibrate the Everest engine Base Camp 4140
|
7.2 Mill the calibration body
▶ Close the safety doors.
▶ Press the Start function key on the control panel.
After approximately 5 minutes, the Everest engine Base Camp stops.
7.2.9 Grind the calibration body side 2
Infilling the milling side of the workpiece
After machining the first side, the machine move to start position, and the gripping
yoke is vertical .
▶ Open safety doors.
▶ With the compressed air gun, remove coolant, chips, etc. from the blank.
The side of the blank to be processed must be clean and dry.
CAUTION
Risk of injury from the use of compressed air
Injuries can occur when using compressed air, if the necessary protective equip‐
ment is not used.
▶ Wear safety goggles.
CAUTION
Damage to the Spindle
The spindle may be damaged by the improper use of compressed air.
▶ Only ever direct compressed air onto the workpieces, and never to the spindle.
▶ Open safety doors.
36/51
