Operating Manual
18
Original Operating Manual
As necessary
Replace worn sliding pieces (2) by removing nut (5) from each cylinder (6). Pull the
arms to the side to remove (see Chapter 3.1). Remove the greasing nipple (1) and the
screw/s (3, 3a). Replace the sliding pieces (2). When installing the new sliders, make
sure that the axial stops (4) are correctly seated. Refit the screw (3, 3a) and the
greasing nipple (1). Push the arms into clamp body and reinstall nuts (5) of cylinders
(6).
After installing or removing a cylinder (6), always check the clearance between the
cylinder mount and nut of the cylinder (8). Cylinders are installed with axial clearance
of 1.5 to 2 mm.
6.3.3 Rotator and flange
