Operating Manual
12
Original Operating Manual
A change in pressure is necessary only, if the load
slips or
is damaged.
Make the settings in the numerical sequence and in the direction of the arrows.
The pressure indication on the manometer gauge drops after clamping.
This is
not
a malfunction of the attachment, being caused by the installation of a
transmission
5.
Operation
(related to the bolted on fork arms. With other arm designs, these operating instructions must be
extended with instructions from the operator.)
5.1
General
At least once per working shift, the machine and equipment must be
inspected for visible damage and defects.
Repeat faults to your superior and have them rectified without delay.
Be aware of persons present in the area where you are working or driving
and ensure that they are not endangered.
Do not transport any load exceeding that specified on the residual load
plate for the particular combination of lift truck and attachment.
Note the load-bearing capacity of the attachment as stated on the rating
plate. This figure always represents the load carried by two or more fork
arms.
The nominal capacity of the forks must exceed the load.
Ensure that fork arms and arms that clamp a load are closer together at the
tips than at the back. As a result you need a larger clearance for moving in.
