71
Mainmenu - Settings
Remote Control Code
After calling up the menu you will see the
following on-screen display:
You can use this function to allow
you to operate several receivers
(e.g. four UFS 946/ CI+ units) using
the same remote control. You can
assign each receiver its own remote
control code. This pre-supposes
that the receiver was supplied
with the RC 670 remote control
(e.g. UFS 946/CI+) or with the RC 660
remote control (e.g. UFS 902).
You can now use the remote control for your receiver to set a new remote control code (the remote
control code 1 is set as standard). Press the following buttons simultaneously:
-
+
+
for remote control code 1
-
+
+
for remote control code 2
-
+
+
for remote control code 3
-
+
+
for remote control code 4
Now press the
button. If the receiver does not close the on-screen display, the receiver and the
remote control are not set to the same remote control code. Check your setting again.
To set the remote control for whichever remote control code is required in future, proceed as follows:
-
+
for remote control code 1
-
+
for remote control code 2
-
+
for remote control code 3
-
+
for remote control code 4
Summary of Contents for UFS 946/CI+
Page 122: ...122 For your notes...
Page 123: ...123 For your notes...
