54
Mainmenu - Channel Search
Manual channel search
After calling up the menu you will see the
following on-screen display:
The
buttons allow you to select
different sets of parameters for the search.
Satellite
Use the
buttons to select the satellite on which the transponder you want to scan is located.
By pressing the
button at this point, you can view a list of the installed satellites. Use the
buttons to select the satellite you want and confi rm with the
button. Make sure your reception
system is aligned to this/these satellite(s). If you want to search several transponders on one satellite,
you should start an automatic search of the transmitting satellite.
Transponder Frequency
Use the
buttons (transponder frequency already saved) or the number pad (transponder
frequency not yet saved) to select the transponder frequency on which the channel being sought
is transmitted. By pressing the
button at this point, you can view a list of the transponders
stored for the selected satellite. Use the
button to select the desired transponder and confi rm
with the
button. At the bottom right of the on-screen display, the receiver shows the current
signal strength and signal quality of the selected transponder.
The “Polarisation” and “Symbol Rate” options need be specifi ed only if the transponder has yet
to be saved.
Polarisation
Press the
buttons to select the correct polarisation (horizontal or vertical).
Symbol Rate
Use the number pad to enter the corresponding symbol rate.
Summary of Contents for UFS 946/CI+
Page 122: ...122 For your notes...
Page 123: ...123 For your notes...
