6
Safety Instructions - Important Notes
Mains cable
Make sure that the mains cable
(power supply cable) is not damaged.
Units with a damaged mains cable
must be disconnected from the
mains (unplugged at the mains
power socket) and repaired by an
electrical specialist before being
used. Only use the power pack
supplied (if available)!
Risk of fatal injury due to electric
shock!
Danger!
Cleaning
Disconnect the mains plug before
cleaning the unit. Only use a dry
cloth for cleaning and only clean
the outer surface. Never open
the casing of the unit.
Touching the parts inside the unit
carries a risk of death due to electric
shock!
Playing children
Make sure that children do not
push any objects into the ventilation
slots.
Risk of fatal injury due to electric
shock!
Earthing
The antenna system must be
earthed as speci
fi
ed or equipoten-
tially bonded.
EN 60728/11 and any national
regulations must be complied with.
Risk of voltage surges due to
lightning strikes!
Power supply voltage
Only operate the unit at the speci
fi
ed
mains voltage (indicated on the
rear of the unit or on the external
power pack). The unit may only be
connected to the mains and turned
on once it has been connected to
the antenna and to the TV set or
the cable network and PC.
If the mains voltage is too high,
there is a risk of fi re!
Moisture, direct sunlight, heat,
naked
fl
ames
Protect the unit against moisture,
dripping and splashed water (do
not place any
fi
lled objects such
as vases on top of the unit). Do not
place the unit close to a heater or
expose it to direct sunlight and do
not operate it in damp locations.
Only use the unit in a moderate
climate, not in tropical conditions!
Place no naked
fl
ames such as
candles on top of the unit!
There is a risk of fi re!
Ventilation
The heat generated in this unit is
adequately dissipated. However,
the unit should never be installed
in a cupboard or on shelves with
inadequate ventilation. Never cover
the cooling slots on the unit (e.g.
with other equipment, magazines,
tablecloths, clothing or curtains)!
Do not place any objects on top of
the unit. Unless stated to the contrary
in the “Connection and Set-Up” and
“Installation” sections in the manual
included, maintain a clearance of at
least 10 cm above the unit, 2 cm to
either side and 5 cm behind the unit,
to allow unobstructed dissipation of
the heat generated.
There is a risk of fi re!
Batteries
If your unit was supplied with
batteries (e.g. for the remote control),
take care that the batteries are
not exposed to excessively high
temperatures, direct sunshine or
fi
re.
Exchange the batteries only with
types that are identical or equivalent.
Otherwise the batteries and also the
remote control may be damaged.
Comply also with the safety
instructions stated on the batteries:
There is a risk of explosions!
Warning!
Warning!
Warning!
These two pages contain important information about operation, installation location and connection of the
unit. Read these instructions carefully before setting up the unit.
Do not
cover
Summary of Contents for UFS 900sw
