Kathrein UFS 900sw, Operating Manual

Page: 23 / 108

23
Connection and setup
LNB Type
If your reception system does not have a Universal LNB, use the

buttons to select the
LNB types that are used in your reception system. You can choose from the following LNB types:
- Universal or
- Single
LNB Low Frequency
You only need to specify this data if your LNB type is not “Universal LNB”. For this, refer to the
documentation supplied with your LNB. Enter the LNB low frequency, using the numeric pad or
the

buttons.
LNB High Frequency
You only need to specify this data if your LNB type is not “Universal LNB”. For this, refer to the
documentation supplied with your LNB. Enter the LNB high frequency, using the numeric pad or
the

buttons.
Test transponder (this works only after a new registration)
To check whether the settings that you have made are correct, use the

buttons to move to
the “Test transponder” fi eld. Use the

buttons to select the required transponder from the
various ones listed. If your settings are correct, you will see at the top right of the screen the live signal
of a channel from the currently selected transponder.
If you do not receive a signal, check your settings again and if necessary call for expert help.
You have now completed all settings for the fi rst satellite. Press the

button. If at “Number of
Satellites” you selected two satellites, fi rst follow the same procedure to perform the settings for the
second satellite.
When you have fi nished the satellite con fi guration, press the

button. The receiver automatically
switches back to the “Antenna Con fi guration” overview. Now use the

buttons to select the
“New registration” line and press the

button to con fi rm.
LNB = Low Noise Block converter (feed system)