Karmann-Mobil DEXTER 600, Operating Manual

Page: 143 / 194

Heating
EN 54
8.4 Heater control panel
The heater is controlled with a dedicated control panel (Truma CP plus). This is located next to the control
panel above the kitchen unit door.
Control panel for Truma CP plus
Different values and parameters can be selected, changed and stored with the turn/push button.
The selected menu items will flash.
8.5 Operating the heating system
Turn the turn/push button to the right to scroll through the symbols of the upper menu until the heating
symbol appears.
Press the button to confirm the selection. Turn the button to the right again to select the desired
temperature.
8.6 Operating the heating with hot water supply
Turn the turn/push button to the right to scroll through the symbols of the upper menu until the heating
symbol appears.
Press the button to confirm the selection, then select the hot water symbol and press the button again to
confirm the selection.
8.7 Faults
In the event of a fault, the Truma CP+ controller immediately switches to the “Fault” menu and shows the
error code of the fault. Refer to the manual for the Truma CP+ controller for information about trouble-
shooting and instructions for eliminating faults.
After the problem has been identified and corrected, reset the system by pressing and holding the
turn/push button for at least four seconds to switch off the unit. Then turn the unit on again.
Symbol for energy
selection menu
Menu cell (bottom)
Turn/push button
Symbol for
heating menu
Time indicator
Symbol for
hot water menu
Status line
Menu cell (top)
Settings/values
Display of 230 V
mains voltage
(mains power)
Return button