Kardia Standard v.103, Installation Manual

Page: 38 / 52

37 /
Examples of where sensors should be placed
• Under kitchen cabinet.
•
Integrated cistern.
•
In rooms with water installations where there is no floor drain.
Connection of sensor cable
1. When installing the sensor cable, connect it to the controller
box marked "CABLE" on the base. (It programs itself.)
2. The plug for the controller box is plugged into the wall outlet.
3. The light on the controller should show GREEN - which
means the system is in operation. RED indicates that there is
a leakage and the valve (s) close(s) automatically.
4. TEST - Put cable with no insulation into a glass of water.
5. The controller sends three signals and the light switches to
red. The valve (s) close(s). Check the water tap to make sure.
6. Press the RESET button on the controller. The light will
change to GREEN and the valve (s) will open. Check that
there is water coming from the water tap again.
7. Install sensor cable where leakage can occur - MAKE SURE
that the insulated field on the cable is face down on the floor.
8. The cable can be fixed to the floor with silicone or with glue.
Connection of wireless sensors
1. Valve (s) and junction box must be installed.
2. Plug the connection box to the wall outlet.
3. The light on the control box should show GREEN.
4. Open the cover of the wireless sensor and insert the battery.
5. Bring a non-insulated part of the cable into contact with
water. (For example, in a glass of water.)