13
Operations
Handle Installation
HOLE
PIVOT
HANDLE
ASSEMBLY
MOTOR
PLUG
DECK
ASSEMBLY
4
5
6
3
2
1
HANDLE
RECEPTACLE
86402430 Operator’s Manual - Floor Burnisher
The machine is shipped with handle unassembled.
Follow these steps for installation:
1.
Remove handle and deck assembly from carton.
2.
Attach handle assembly to base using hardware
kit (86219680 – PRV NO. 47331) (attached to
handle in plastic bag) items 1, 2 and
NOTE: The spacers (item 1) are required for the
correct operation of the handle. The spacers are
positioned completely inside the pivot holes in the
casting, and are held in place by tightening the
bolts and washers (items 2 and 3 against the
spacer.
3.
Remove bolt, nut and washers (items 4, 5 and 6)
from lower block on handle assembly. Attach
links as shown. Tighten bolt and nut securely,
then back off 1/4 to 1/2 turn.
4.
Check handle for movement up and down.
5.
Plug motor cord into handle cord receptacle.