Kärcher MIC 26, Operator'S Manual

Page: 67 / 298

-
30
– Use a water and antifreeze mixture to refill.
– Do not mix different antifreeze types.
– Use only soft water for the water and antifreeze mix-
ture.
– Only top up coolant when the engine is cool.
 Remove the right engine panel.
If the cooling water reservoir is completely empty, first fill
up the radiator:
1 Radiator lid
2 Drain screw
 Unscrew the radiator cap.
 Fill the radiator slowly all the way to the top without bub-
bles.
 Screw on the radiator lid.
Fill the cooling water equalising reservoir:
 Remove the lid of the equalising reservoir.
 Fill the equalising reservoir to the bottom mark.
 Close the lid for the equalising reservoir.
 Start the engine and let it warm up.
 Check the filling level in the coolant expansion tank.
While the engine is warm, the cooling water level must
be at the top mark.
 If the cooling water level is too low, shut the engine off,
let it cool off and fill the missing cooling water volume
into the cooling water equalising reservoir.
1 Locking tap
2 Union joint
3 Container
4 Wire filter
5 Float
6 Spring
 Ensure that the drain-off tap is open.
 Check whether the floater is located on the bottom of
the water separator.
If the floater is not on the bottom, there is water in the
water separator and the water separator must be
cleaned.

Danger
Risk of explosion!
– Do not carry out maintenance tasks in closed rooms.
– Smoking and open flames must be strictly avoided.
 Close the stop valve.
 Place the collection trough under the water separator.
 Loosen the union joint.
 Remove the water separator reservoir.
 Remove the spring and the floater from the reservoir.
 Clean the interior of the reservoir.
 Clean the wire filter.
 Check the O-ring between the reservoir and the top
part of the water separator.
 Reassemble the water separator.
 Open locking tap.
 Deaerate the fuel system
1 Stop cock
2 Union joint
몇
WARNING
Risk of injury due to spilled fuel! Collect and wipe up spilled
fuel immediately.
Wear safety gloves.
 Switch off the engine and let it cool down.
 Close the locking tap at the water separator.
 Place the collection trough under the fuel filter.
 Unscrew the fuel filter.
 Apply a thin film of fuel to the seal of the new fuel filter.
 Screw the new fuel filter in fingertight.
 Open the locking tap at the water separator.
If the tank is empty or if the fuel filter was replaced, the fuel
system must be bleeded.
 Check if the fuel tank is filled.
 Open the locking tap at the water separator.
 Start the motor.
 Close the stop-cock when the system is bled.
10.5.14 Refill cooling water
10.5.15 Check the water separator
10.5.16 Clean the water separator
10.5.17 Replace the fuel filter
10.5.18 Bleed the fuel system
67 EN