715-721 • HDS-NG LP • 9.800-160.0 • Rev. 4/10
15
PRESSURE WASHER
OPERATOR’S MANUAL
SHUTTING DOWN AND CLEAN-UP
STORAGE
CAUTION: Always store your pressure
washer in a location where the temperature
will not fall below 32°F (0°C). The pump in
this machine is susceptible to permanent damage
if frozen. FREEZE DAMAGE IS NOT COVERED BY
WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure
hose.
STEP 1: Remove detergent suction
tube from container and insert into
one gallon of fresh clean water. Pull
trigger on spray gun and siphon
water for one minute.
STEP 2: Turn/push burner switch to "OFF" position. Open spray
gun allowing water to cool. Then turn/push pump switch to “OFF”
position.
STEP 3: Turn off water supply.
STEP 5: Engage the spray gun
safety lock.
STEP 4: Press trigger to release
water pressure.
Safety
Latch
3. Turn on the machine for a few seconds, until
remaining water exits. Turn off immediately.
4. Do not allow high pressure hose to become
kinked.
5. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
Pump/Burner Switch