Kärcher HDS 1195, Operating Instructions Manual

Page: 22 / 318

English HDS Super, HDS 655, HDS 695 S, HDS 895 S, HDS 1195 22
Setting cleaning temperature
Set the temperature regulator (item 24) to the
required temperature
30°C to 90°C
Hot water cleaning
1 00°C to 1 50°C
Clean with steam, with
steam nozzle - 4.766-023,
at HDS
11 95 - 4.766-024
Setting operating pressure and flow rate
Figure 9
Turning regulator clockwise: Increases
operating pressure (MAX)
Turning counter-clockwise: Reduces operating
pressure (MIN)
Servopress control
Set the temperature regulator (item 24) to
max. 98°C.
Set regulator to maximum operating pressure.
Figure 8
Operating pressure and flow rate can be set at
handgun.
Set pressure on unit if use is to be made of
reduced pressure for a lengthy period.
See Figure 9
Measuring out the cleaning agent
* Use cleaning agents sparingly to protect the
environment
* The cleaning agent must be suitable for the
surface to be cleaned.
Set the concentration of the cleaning agent
according to the manufacturer's
recommendations at the cleaning agent
metering valve (item 30)
Approximate values at maximum operating
pressure
Intended use
Cleaning of: Machines, vehicles, buildings,
tools, facades, terraces, garden tools, etc..
*
Heed appropriate safety regulations for use at
petrol stations or in other hazardous
environments.
Please ensure waste water containing mineral
oil does not contaminate soil, lakes and rivers or
the sewerage system. Therefore, please wash
engines and underbodies only in appropriate
washing installations provided with oil traps.
Working with high-pressure nozzle
Spray angle is crucial to efficiency of high-
pressure jet.
Use is normally made of 25°fan jet nozzle
(included).
Recommended nozzles, available as
accessories
–
For stubborn dirt
0°full jet nozzle
– For delicate surfaces and slight contamination
40°fan jet nozzle
–
For thick layers of stubborn dirt
dirt blaster
– Nozzle with variable spray angle, for
adaptation to various cleaning tasks
variable-angle nozzle
Cleaning
* Set pressure/temperature and cleaning-agent
concentration in line with surface to be
cleaned
* Always start by directing high-pressure jet
from a good distance at object to be cleaned
to avoid damage caused by excessive
pressure.
Recommended cleaning method
Loosen up dirt:
Spray on cleaning agent sparingly and allow to
react for
1 ...5 min (do not allow to dry on).
Remove dirt:
Spray off loosened-up dirt with high-pressure
jet.
www.motralec.com