6
Step 6: Removing Projector from Ceiling
The Projector Adapter
(V)
is designed to be easily
removed from the ceiling plate or extension tube for
cleaning, servicing, realignment and tensioning, as
shown in Diagram H.
Remove the two Safety Screws (
O
) holding the
Projector Adapter to the ceiling plate or extension
tube.
Gently push up on the Projector / Projector Adapter to
disengage the Spring Loaded Locking Tabs.
Turn the projector slightly left or right so the locking
tabs cannot re-engage into the ceiling plate or
extension tube, and pull the projector down to
remove.
WARNING
Support the weight of the projector so it does not fall from your mount.
O
O
Diagram H
6.1
6.2
6.4
6.5
6.6
6.3
Spring Loaded
Locking Tabs
Step 5: Tilt the Projector
The P301 tilts up to 20
°
in any direction, by way of a ball joint inside the Projector Adapter (
V
). Once the
projector is mounted to the ceiling plate, you can adjust the tilt by holding the projector and pushing it in the
direction you need. The tension should be firm, so that the projector will remain in the position you desire
when you stop applying pressure.
NOTE: The Projector Adapter (
V
) has a tensioning ring that comes pre-tensioned from the factory. If the ball
joint is too tight to move with reasonable pressure, or too loose to stay in position, you will need to adjust
the tension. Should you find your installation requires this ring to be adjusted and re-tensioned, remove the
projector from the ceiling as described in Step 6, and follow the tensioning procedure as described in the
optional Step 7.
Step 4: Attach Projector to Ceiling
The P301 has two spring loaded locking tabs that allow
easy installation to the ceiling plate assembly.
Push the Projector Adapter
(V)
up into the ceiling plate
or extension tube. The 2 spring loaded locking tabs
will catch in 2 of the 4 square holes in the ceiling plate
or extension tube. Take caution to ensure the Projector
Adapter
(V)
engages; see Diagram G.
Once you have the Projector Adapter locked into the
ceiling plate or extension tube, install the 2 Safety Screws
(
O
).
The projector can now be gently twisted left or right, or
/- 20° to aim at your screen.
Diagram G
O
O
V
Spring Loaded
Locking Tabs
4.1
4.2
