INITIAL INSTALLATION MANUAL
AF INTEGRA / AF-H INTEGRA
PAGE: 19
JUN 01/2011
(1)RC100
RC100 RCP is supplied as a kit (
Refer to Figure 18: RC100 mounting
diagram
).
Connection of RC100 requires a 3-wire bundle or 5-wire bundle if an
outside buzzer is connected. A pin-to-pin wiring has to be provided by the
installer with AWG24 wires. Shielded wires are recommended.
The wires are soldered to the switch pins, a resistor and LED pins. This
operation can be carried out before installation.
On the ELT side, the wires are soldered to a 12-pin plug that can be either
a standard "DIN12 connector" (P/N S1820514-03) or a connector with an
integrated serial memory module called "Programming Dongle"
(P/N S1820514-01).
Mount and install RCP
Refer to Figure 18: RC100 mounting diagram
NOTE: Pins of LED, pins of switch and resistor must be protected by heat
shrinkable sleeves.
- Place the front plate (1) on the instrument panel;
- Trace the centers of the two holes according to drilling mask supplied;
- Drill a hole Ø 8 mm for the LED mounting (2) (top of the panel);
- Drill a hole Ø6.5 mm for the switch (3) (bottom of the panel);
- Tear off protection from self-adhesive film;
- Stick the front plate (1) on the instrument panel;
- Install the LED mounting (2), with washer (2a) and nut (2b). Tighten nut;
- Solder the resistor (4) to pin 1 of Switch (3);
- Connect the anode (long pins) of LED (5) to pin 2 of switch (3);
- Make a strap between pin 3 of switch (3) and resistor (4);
- Connect wires to pin 2 of switch (3), the resistor (4) and the cathode
(short pins) of LED (5);
- Stuck the "identification label" (6) on the cable bundle near the switch;
- Insert the LED into the LED stand (7) taking care the flat part of the LED
be in front of the flat part of the LED stand;
- Insert LED (5) fitted with LED stand (7) inside the LED mounting (2);
- Install the switch (3) with washer (3a) and nut (3b), locked position
upwards. Tighten nut.
Summary of Contents for AF INTEGRA
Page 59: ......