5
WING ASSEMBLY
This sequence will allow for fast assembly of the
wing assemblies.
Assemble the ailerons to the wing panels as
follows:-(Larger engine planes use ROBART
POINT HINGES)
Remove ailerons and hinges from panels.
Place T Pins in hinges and insert hinges into
ailerons.
Carefully attach ailerons to wing panels, aligning
the ailerons with wing panel ends.
Remove pins and close hinge gap.
Carefully glue hinges using THIN CA. Glue top
and bottom sides of each hinge. Let stand for 5
minutes, then pull to ensure that the ailerons are
firmly attached.
Affix servos with required extensions.
Attach Control Horn as shown using the 3 small
screws.
Attach horn to servo using a 4-40 control rod and
supplied control rod connector.
At the servo end, I bent the rod and used a
keeper. This method is simple and secure.
Locate and install 8 – 3 X 18mm bolts in outer
wing panels at strut locations.
Locate and install 2 – 4 X 30mm and 2 – 4 X 20
mm bolts in center section of top wing.
(We suggest that you trial fit the bolts at this
time to ensure easy assembly later on. I used a
bit of light oil on bolts to lubricate.)
Insert upper wing tubes into center and outer
panels and ensure a perfect tight fit.
