6
Using a 3/32 or 2.75mm drill bit, drill 4 holes in
bottom of outer and center panels where
indicated by existing small pilot holes.
Drill ONLY until bit enters the metal tube.
Install the 4 – 3 X 18mm bolts and washers, It
will be tight as you thread through the tube.
Now is a good time to apply the large Python
decal to the upper wing. Take your time and
carefully cut out the decal.
Measure the decal and wing to find center and
mark with tape.
I found the best way to apply was to remove the
backing on ½ of the decal and carefully apply
ensuring that all bubbles were removed. Then I
removed the backing from the other half and
applied.
Once applied, Carefully slice the decal at the
wing panel separation lines.
To complete the bottom wing assembly, locate
the 2 bolt assemblies and temporarily assemble.
On final assembly, (mounting wings to fuselage),
you will install using lock tite or glue, leaving
sufficient space inside the Fuse to allow
installation of bolt wheel and cotter pin.
TAIL SERVOS
Install elevator servos on each sides of the
fuselage. Mount the servo arms pointing upward.
Extend the servo leads with 24”, servo extension
wires and place inside the fuselage. Position the
extension wires to suit and temporary secure the
loose end of the extension wires at the receiver
end. (Option: secure the extension wires in the
fuselage if so desired).
Fuselage Decals
We suggest cutting out and applying the fuselage
decals at this time. It is easier to carefully work
with them to ensure a bubble free / wrinkle free
application if fuselage is placed on it’s side.
