1. Printer is not turned on.
2. Printer is working, but Print prepara�on is not completed.
3. Printer is ready, but print won’ t start a�er sending data.
FAQ
4. Printer is working, but paper is not foamed.
5. Paper is foamed, but too low/tall/ rough.
6. would like to adjust volume of Voice Guidance.
7. Paper is jammed.
Check power cable is connected with printer and outlet properly.
If cable is connected properly but it is not turned on, call the service center.
When printer shows message from “Voice Guidance or Message on screen” , or
“Power/Message Lamp” is shown, follow the step ch10.
If problem s�ll cannot be solved, call the service center.
(1) check Printer “EasyTac�x” is selected before prin�ng.
(2) See LED lamps(Power/Message Lamp) status have no problem.
(3) If printer driver is not installed properly, uninstall the driver and install again.
(4) If there is no solu�on from (1) to (3), or not be solved, contact the service center.
(1) Press opera�on bu�on for more than three seconds and check paper is fed out.
(2) If paper is remain in the printer and cannot take it out, contact the service center.
Refer to Ch.9 “Printer Driver Specifica�on” .
* You can set OFF(silent)/Small/Middle/Big.
When you s�ll cannot adjust the volume, contact the service center.
(1) Check using dedicated paper. Do not use other paper.
(2) Follow the step Ch.9 “Printer Driver Specifica�on” .
(3) Check the se�ng and if s�ll cannot be solved, contact the service center.
(1) Check using dedicated paper. Do not use other paper.
(2) Follow the step Ch.9 “Printer Driver Specifica�on” .
(3) Check the se�ng and if s�ll cannot be solved, contact the service center.
Opera�on Manual
Chap.12
Summary of Contents for TactPlus.
Page 1: ...user manual...