ULTRAFLOW® 54 DN15-125
48
Kamstrup A/S · Technical description · 5512-2464_D1_GB_09.2021
6.10.1.4
Mounting of angle bracket 3026-858
Angle bracket 3026-858 is included with ULTRAFLOW® 54 (type 65-5-XXXHX-XXX) and can be easily mounted on both
sides of the electronics case as shown in
and, if necessary, also be easily removed again:
A Fasten the hooks of the angle bracket around the edge of one of the sides of the electronics case (see detail drawing).
Note that the angle bracket can in principle be mounted on either side of the electronics case. Although the type label
is fairly robust, it must be handled with care if the angle bracket is to be mounted on this side. The signal cable on the
other side is flexible enough to be inserted between the electronics case and the angle bracket.
B Move the angle bracket around the side edge towards the electronics case.
C Press the angle bracket against the electronics case cover at the indicated positions and click it on (C1). Be aware that
there is enough room for seal wire between angle bracket and electronics case. If the angle bracket needs to be
removed, the snap lock can be opened and pulled backwards with your fingers (C2).
Figure 25. Mounting the enclosed angle bracket on ULTRAFLOW® 54 (type 65-5-XXXHX-XXX ):
(A) Adjusting, (B) turning and (C) closing (opening) the angle bracket.
B
A
C1
C2