9
Using Your Kambrook Heater
Before First Use
Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas. The heater must
always be operated with the rear air
filter in position.
Turning Your Heater On
Before turning the heater ON, turn the
thermostat control to the minimum
position, then turn the heat settings
control to the ‘OFF’ position.
Plug the cord into a 230V or 240V
electrical outlet. Be sure the plug
fits tightly as a loose fit will cause
overheating and damage the plug.
NOTE:
To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit with your heater
when you switch the unit on.
With the thermostat control set to
the maximum position, turn the
heat settings control to the desired
temperature.
Turning the heat settings control to
setting ‘1’ will set the heater into low
heat mode (800 watts).
Turning the heat settings control to
setting ‘2’ will set the heater to high
heat mode (1500 watts).
Turning the heat settings control to fan
mode is for fan-only operation to
circulate air with no output of heat.
When any of these modes are
selected the power indicator light of
the heater will illuminate to indicate
that power is on.
To turn the heater OFF, turn the heat
settings control to the ‘OFF’ position.
This will turn the power indicator light
off. Turn off at the power outlet and
remove the plug from the power outlet.
NOTE:
There is a tip-over switch
fitted to this heater. If the heater is
tipped over, it will automatically
turn off. The heater will need to
be placed back into the upright
position to resume heating again.
Setting the Variable
Thermostat Setting
The Variable Thermostat Control Dial
acts as an automatic thermostat and
can be used to maintain your desired
room temperature.
1.
Turn the Heat Setting control dial
to setting ‘2’ and the variable
Thermostat Control dial to the
‘MAX’ setting.
2.
Once a comfortable room
temperature has been reached,
slowly turn the thermostat control
dial towards the ‘MIN’ setting until
a “click” sound is heard.
3.
At this setting, your heater will
automatically cycle on and off
to maintain the desired room
temperature.
4.
Turn the heater off by turning
the Heat Setting dial to the
‘OFF’ position.
