11
• Ensure that the heater is switched
OFF, then switched off and
disconnected from the power
outlet before cleaning.
• Use a clean, dry cloth to clean
the external surfaces of the
heater. If the heater has collected
dust or dirt inside the unit or
around the elements, have the
unit cleaned by a qualified
service agent. Do not operate the
heater in this condition.
• Do not attempt to open the case
of the heater at any time as there
are no customer serviceable
parts inside.
• When not in use, store the heater
(preferably in its original box) in a
cool, clean and dry location.
Cleaning the Filter
• Your Kambrook Personal Ceramic
Heater comes with a mesh filter
located at the rear of the heater
to help keep dust and debris
away from the working parts. It is
recommended to regularly check
your heater filter for clogging and
dust build up. The filter should be
checked after every use to ensure
heating efficient performance.
• Always switch the heater to OFF,
then switch off at the power
outlet prior to removing the filter
for cleaning.
• To access the filter, ensure the
heater is in the upright position
and then remove the filter cover
by carefully pulling out the
outer edge of the cover until it
is completely free of the heater
(see Fig.1).
Care, Cleaning and Storage
Fig. 1
• It is then necessary to separate
the mesh from the filter cover.
Once separated, shake both the
filter cover and the mesh filter
into a rubbish receptacle until all
fine dust particles and debris are
removed. Wipe over with a soft,
dry cloth if required to remove
particles.
• To replace, reinsert the mesh filter
to the filter cover, align the tabs
at the back of the filter cover
with the air inlet opening at the
back of the heater and then press
down on the cover until it “clicks”
(see Fig. 2).
Fig. 2
