background image

5

Important Safeguards For All  

Electrical Appliances

•  Fully unwind the power cord before use. 
•  Connect only to a 230V or 240V power outlet.
•  Do not let the power cord hang over the edge 

of a bench or table, touch hot surfaces or 

become knotted.

•  To protect against electric shock, do not 

immerse the power cord, power plug or 

appliance in water or any other liquid or  

allow moisture to come in contact with the 

part, unless it is recommended in the  

cleaning instructions.

•  The appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities, or  

lack of experience and knowledge, unless 

they have been given supervision or  

instruction concerning use of the appliance  

by a person responsible for their safety.

•  Children should be supervised to ensure  

that they do not play with the appliance.

•  It is recommended to regularly inspect the 

appliance. To avoid a hazard, do not use 

the appliance if power cord, power plug or 

appliance becomes damaged in any way. 

Return the entire appliance to the nearest 

authorized Kambrook Service Centre for 

examination and/or repair.

•  Any maintenance other than cleaning should 

be performed at an authorised Kambrook 

Service Centre.

•  To prevent a possible fire or heat damage, 

allow ample space around the heater  

(at 1.7m at front and 0.5m at the rear, top  

and sides) and do not totally or partially 

block the air inlet or outlets in any manner. 

Check the openings from time to time for 

accumulated dust. Ensure long shag carpet 

does not obstruct airflow under the unit.

•  Do not touch hot surfaces.
•  Switch OFF at the heater and power outlet, 

then unplug and allow heater to cool down 

before cleaning or storing. 

•  Do not use outdoors. This heater is not 

intended for commercial use such as 

construction sites.

•  Use this heater only as described in this 

instruction manual. Any other use not 

recommended by the manufacture may 

cause fire electric shock or injury and voids  

all warranties. 

•  Regularly inspect the supply cord, plug, 

control settings, air inlets and outlets and main 

housing for any damage, If found damaged in 

any way, immediately cease use of the heater 

and return to Kambrook or an authorized 

service agent for inspection or repair.

•  Keep the heater clean. Follow the cleaning 

instructions provided in this book.

•  Always ensure the heater is properly 

assembled before use. Follow the instructions 

provided in this book.

•  Do not operate the heater on a sink or  

drain board.

•  Do not operate the heater on an incline 

plane. Do not move while the heater is 

switched on.

•  To avoid an electrical overload. It is 

recommended that no other appliances are 

plugged into the same circuit as your heater 

when it is in use.

 

NOTE:

 This Kambrook Ceramic 

Heater is electronically controlled 

and will not operate until the 

heater is plugged into a 230V or 

240V power point and switched on. 

•  This appliance is for household use only.  

Do not use this appliance for anything other 

than its intended use. Do not use in moving 

vehicles or boats. Do not use outdoors.  

Misuse may cause injury.

•  The installation of a residual current device 

(safety switch) is recommended to provide 

additional safety protection when using 

electrical appliances. It is advisable that a 

safety switch with a rated residual operating 

current not exceeding 30mA be installed in 

the electrical circuit supplying the appliance. 

See your electrician for professional advice.

•  Always turn the appliance to the ‘OFF’ 

position, switch off at the power outlet 

and unplug at the power outlet when the 

appliance is not in use.

•  Before cleaning, always turn the appliance 

to the ‘OFF’ position, switch off at the power 

outlet, unplug at the power outlet and remove 

the power cord, if detachable, from the 

appliance and allow all parts to cool.

•  Do not place this appliance on or near a heat 

source, such as hot plate, oven or heaters.

•  Position the appliance at a minimum distance 

of 20cm away from walls, curtains and other 

heat or steam sensitive materials and provide 

adequate space above and on all sides for  

air circulation. 

Summary of Contents for KCE75













Reviews: