IASMANUAL 0821
KAM CONTROLS, INC.
10
10.
Align window of the IAS™ Sampler to face the flowing stream. This can be done by aligning the Flow Indicators in
parallel with the main pipe. The Flow Indicators are located at the bottom of the Actuator Housing. FIG. 3-9.
11.
Push the IAS™ Sampler in until the MID Mark is at the top edge of the Locking Collar. FIG. 3-9.
I N S TA L L AT I O N C O N T I N U E D
FIG. 3-9
MID Mark
Flow Indicators
12.
Re-tighten the Socket Cap Screws so that the gaps
between each half of the Locking Collar are even, as
tight as possible done by hand. Failure to properly
tighten could result in ejection of the unit under
process conditions. FIG. 3-10.
13.
Use a 3/4" wrench to tighten the Hex Nuts holding
the Locking Collar from ¼ to ½ of a turn. The Hex
Nuts holding down the Locking Collar should never be
over-tightened. Their major function is to apply light
pressure on the Chevron Packing to ensure a seal
between the Seal Housing body and the Insertion
Shaft. FIG. 3-11.
Socket Cap Screw
Locking Collar
Hex Nut
FIG. 3-11
SECTION A-A
SCALE 1 / 2
1
1
2
2
A
A
B
B
MATERIAL
FINISH
DRN
THIS DRAWING IN DESIGN AND
DETAIL IS THE PROPERTY OF
KAM CONTROLS INCORPORATED.
IT SHALL NOT BE REPRODICED
AND SHALL BE RETURNED TO US
ON DEMAND
ALL RIGHTS RESERVED
APPVD
SCALE
DATE
DWG NO.
REV
TITLE
UNLESS OTHERWISE
SPECIFIED
ALL DIM IN INCHES
ANGULAR TOL ±1/2
FRACTIONAL TOL ±1/64
3 PLACE DEC ±0.005
2 PLACE DEC ±0.010
REMOVE ALL BURRS
BREAK SHARP EDGES
DO NOT SCALE DWG
SHEET
SS316
Gerry Alejos
1:2
03-13-2013
A
2"-150 Seal Housing
Assembly
211-001-000
Kam
Controls
Incorporated
3939 Ann Arbor Dr.
Houston TX 77063
USA
WWW.KAM.COM
1
OF 1
A
1/4
5/32
FIG. 3-10
Top View Locking Collar
Socket Cap Screw
Locking Collar
Gap
Hex Nut